Configuring Intervrf Route Redistribution For Rip - Avaya 8800 Configuration Manual

RIP configuration using the ACLI
Variable
metric <0-255> [vrf-src
<WORD 0-64>]
route-map <WORD 0-64>
[vrf-src <WORD 0-64>]

Configuring interVRF route redistribution for RIP

Configure a redistribute entry to announce certain routes into the RIP domain, including static
routes, direct routes, RIP, OSPF, or BGP. Use a route policy to control the redistribution of
routes.
Prerequisites
• RIP is globally enabled.
• A route policy is configured.
• The VRFs exist.
• Access VRF Router Configuration mode.
Procedure steps
1. Configure the redistribution of routes from a VRF to RIP. Create the redistribution
2. Apply a route policy if required:
3. Use the following variable definitions table to configure other parameters.
4. Enable the redistribution.
5. Ensure that the configuration is correct:
108 Configuration — OSPF and RIP
Configures the metric to apply to redistributed routes.
Configures the route policy to apply to redistributed routes.
instance:
ip rip redistribute <ospf|bgp|static|direct|rip>
ip rip redistribute <ospf|bgp|static|direct|rip> route-map
<WORD 0-64> [vrf-src <WORD 0-64>]
ip rip redistribute <ospf|bgp|static|direct|rip> enable [vrf-
src <WORD 0-64>]
Value
June 2011