Avaya 8800 Configuration Manual page 81

Variable definitions
Use the data in the following table to use the following commands:
• config ip rip interface <ipaddr>
• config ip vrf <vrfName> rip interface <ipaddr>
auto-aggr <enable|disable>
cost <cost>
default-listen <enable|
disable>
default-supply <enable|
disable>
disable
enable
holddown <seconds>
in-policy <policy name>
info
listen <enable|disable>
out-policy <policy name>
poison <enable|disable>
Configuration — OSPF and RIP
Variable
Enables or disables automatic route aggregation on this
interface. When enabled, the switch automatically
aggregates routes to their natural mask when they are
advertised on an interface. The default is disabled. (This
configuration does not change the mask for all routes;
instead it aggregates only the routes with a mask length
longer than the natural mask.)
Indicates the RIP cost for this interface.
<cost> is an integer in the range of 1 to 15. The default is
1.
Enables or disables the switch to accept the default route
learned through RIP on this interface. The default is
disabled.
Enables or disables an advertisement of a default route on
this interface. This command takes effect only if a default
route exists in the routing table.
Disables RIP on the interface. The default is disabled.
Enables RIP on the interface.
Configures the RIP hold-down timer for the interface in
seconds. The range is 0 to 360. The default is 120.
Specifies the policy name for inbound filtering on this RIP
interface. This policy determines whether to learn a route
on this interface. It also specifies the parameters of the
route when it is added to the routing table.
Displays the RIP configuration on this interface.
Enables or disables the switch ability to learn routes from
this interface.
Specifies the policy name for outbound filtering on this RIP
interface. This policy determines whether to advertise a
route from the routing table on this interface. This policy
also specifies the parameters of the advertisement.
Configures whether (enabled) or not (disabled) RIP routes
on the interface learned from a neighbor are advertised
Configuring RIP on an interface
Value
June 2011 81