ZXR10 5900E Series User Manual (Ethernet Switching Volume)
Command
vlan {<vlan-id>|<vlan-name>}
ZXR10(config)#
Command
vlan list <vlan-list>[name <vlan-name>]
ZXR10(config)#
Command
ZXR10(config-vlanX)#
6
Confidential and Proprietary Information of ZTE CORPORATION
in a user's subnet, they cannot be allocated to other users. This
causes waste of IP addresses.
SuperVLAN effectively resolves this problem. It merges several
VLANs (called sub-VLAN) to a SuperVLAN so that they can use the
same IP subnet and default gateway.
With the SuperVLAN technology, the ISP needs only one IP sub-
net for its SuperVLAN. It creates a sub-VLAN for each of its users.
These sub-VLANs can use flexibly the IP addresses in the Super-
VLAN subnet and share the default gateway of the SuperVLAN.
Each sub-VLAN is an independent broadcast domain, ensuring user
isolation, and communicates with other sub-VLANs through Super-
VLAN routing.
Configuring VLAN
Creating VLAN
Creating a VLAN in VLAN Database
To create a VLAN in VLAN database, use the following command.
Setting VLAN Name
To set VLAN name, use the following command.
name <vlan-name>
VLAN name uniquely identifies a VLAN. This can be a group, de-
partment and region name. By default, a VLAN name is "VLAN"
+ VLAN ID. VLAN ID includes four digits (0s are pretended when
there are less than four digits). Name of VLAN 4 is VLAN0004.
Function
This creates specific VLAN and
enters into VLAN configuration
mode.
Function
This creates a VLAN in VLAN
database.
Function
This sets VLAN name.