Table of Contents
Advertisement
2. On the ZR 4000 LXR if attempting to
shift into reverse at too high engine
RPM (above idle RPM), the reverse
function will be cancelled and the
coolant temperature warning icon will
flash. This indicates the reverse
switch button was pressed at too high
RPM. The operator must reduce
engine RPM below 4000 and press
the button a second time.
CAUTION
Never shift into reverse while the
snowmobile is moving forward as it is
hard on the driven clutch torque
bracket and the cam rollers.
CAUTION
Never engage the electric starter or
pull the recoil starter rope when the
engine is running or when operating
in reverse. Damage to the engine and/
or either the electric start or recoil
start system will occur.
NOTE: When reverse is engaged, a
reverse icon will illuminate in the
speedometer/tachometer
reverse alarm sounds.
3. If the throttle lever is compressed
before complete reverse engage-
ment, the engine may shut down.
Always wait for the reverse icon to
illuminate and the reverse alarm to
sound before backing up.
! WARNING
Do not use high speed when backing
up. Control could be lost and injury
could occur.
CAUTION
Do not use high speed when backing
up. Damage to the drive belt and
driven clutch components may occur.
NOTE: While operating in reverse,
a "rev-limiter" will activate at 6000
RPM.
4. To shift into forward, stop the snow-
mobile and allow the engine to idle
(under 3000 RPM); then press the
reverse button and release. The for-
ward selection will be complete.
5. After shifting from reverse to forward
(or from forward to reverse), apply
the throttle slowly and evenly to allow
the driven clutch to engage properly.
NOTE: The reverse function is can-
celled whenever the engine is shut off.
After reversing in deep powder snow
conditions, make sure the snowflap
does not become "caught up" in the
track. Track and/or snowflap damage
may occur.
Adjustable Backrest
(Pantera 7000)
The backrest is designed for maximum
comfort and safety. When riding double,
the backrest must be in the passenger seat
position.
To change the position of the backrest,
loosen the two adjuster knobs on either side
of the seat and push the backrest forward or
backward. Tighten both adjuster knobs.
and
a
When riding single, the backrest can be
moved to the forward seat position.
Moving the backrest to the forward
seat
capacity to one person only.
Removable Seat
Pantera 7000
NOTE: If additional cargo is being
added, maximum weight on the snow-
mobile
should not exceed the maximum limi-
tation set for each snowmobile. See
the chart in the Suspension - Over-
load Springs sub-section in the Main-
tenance section for details. Also, the
overload springs should be engaged.
CAUTION
! WARNING
position
limits
(operator/passenger/cargo)
0748-418
the
seating
17
Hide quick links:
Advertisement
Table of Contents
