Table of Contents
Advertisement
3.
Carefully allow the torque bracket to slide off
the stationary sheave hub; then slide spring
off hub.
4.
If cam bracket sliding shoes need servicing.
remove them with a pliers.
5.
Slide moveable face off stationary hub.
II
NOTE: Woodruff key does not have to be
removed to disassemble moveable sheave.
7.
Slide bearing off stationary hub.
Cleaning
1.
Wash grease and foreign matter off all parts
using cleaning solvent.
2.
If drive belt accumulations are on stationary
sheave, hub or moveable sheave. remove the
accumulations using cleaning solvent only.
6.
Remove woodruff key from stationary hub.
Fig. 6-16
•
CAUTION
•
DRIVEN PULLEY
l
92
0700-010
/'
/
~-~/
DO NOT use steel wool or awire brush to clean
driven pUlley parts. Awire brush
er
steel
wool will gouge the sheaves. thus. the drive
belt may not slide 'properly between sheaves.
Decreased performance and possible acceler-
ated belt wear will result.
Whenever a part is worn excessively, cracked,
defective or damaged in any way, replacement is
necessary.
Inspection
4
1. Stationary Sheave Hub
2. Key
3. Bearing
4. Moveable Sheave
5. Shoe Ramp
6, Spring
7. Torque Bracket
8. Snap Ring
9. Spring Pin
KEY
5
A200
1"' ..
6-17
Advertisement
Table of Contents
