Updating Handset Firmware - Avaya D100 Installation And Administration Manual

Administration and maintenance

Updating handset firmware

To update the D160 handset firmware, you must install Microsoft .NET version 4 and you must
use the D160 Upgrade Jig.
To check your version of Microsoft .NET, click Control Panel > Add or Remove Programs.
If you do not have Microsoft .NET version 4, download it directly from Microsoft at:
http://www.microsoft.com/en-us/download/search.aspx?q=.net%204.0%20
If you update the handset firmware on a live system, you must reboot the base station to which
the handset registers once the update completes.
Before you begin
Ensure that the handset battery has enough power to last the duration of the upgrade, which
might be a few minutes. Also, ensure that you have the latest USB-UART driver installed for
the Upgrade Jig (CDM 2.04.06 WHQL Certified), which is also required. Locate the available
Upgrade Jig drivers for each operating system in the Upgrade Jig Drivers folder.
Note that the following procedure has been tested and successfully performed on Windows
XP and Windows 7.
Procedure
1. Connect the Upgrade Jig to the PC through an available USB port.
2. Extract the D160 Firmware Upgrade file to anywhere on your PC.
3. In the extracted folder, run the D160 Handset Writer application.
76 D100 SIP Wireless Terminal Installation and Administration Guide
The D160 Handset Writer window appears:
Comments? infodev@avaya.com
December 2012