Resetting The Base Station Using The Base Station Web Management Interface; Resetting The Base Station Using The Base Station - Avaya D100 Installation And Administration Manual

Resetting the base station using the Base Station Web Management
Interface
Using the Base Station Web Management Interface to reset the base station to factory default
is an alternative method that you should only attempt when System Status Application fails, or
if the base station does not appear in System Status Application at all.
For more information, refer to
If this alternative method also fails, only then should you attempt the ulterior method described
in

Resetting the base station using the base station

Procedure
1. In the Base Station Web Management Interface, navigate to the Setting Menu in
2. Select Reboot Base Station.
3. Select Execute (Factory Initialize).
Resetting the base station using the base station
Only use this method to reset the base station to factory default when the preferred and
alternative methods fail. See
page 80 before you attempt the following method.
Procedure
1. Press and hold the Registration button located on the front of the base station and
2. You can now use the Base Station Web Management Interface to reset the base
D100 SIP Wireless Terminal Installation and Administration Guide
Base Station Web Management Interface
the left navigational pane.
The base station resets to factory default.
Resetting the base station using System Status Application
insert a pin into the Reset button hole also located on the front of the base station.
Hold both buttons for five seconds.
The base station resets the following parameters to the default values indicated:
• IP Address: 192.168.1.100
• Subnet Mask: 255.255.0
• Default Gateway: 192.168.1.1
station. See Resetting the base station using the Base Station Web Management
Interface on page 81.
Resetting the base station to factory default
on page 71.
on page 81.
December 2012
on
81