Avaya D100 Installation And Administration Manual page 51

Procedure
1. Screw the mounting screws directly into the wall or ceiling, or using the wall anchors
2. Gently remove the adapter cover from the back of the repeater by pushing in and
3. Plug the AC adapter connector into the yellow adapter opening, as in the following
4. Without inserting the cover on an angle, carefully replace the adapter cover, and
5. Mount the repeater on the mounting screws installed in step 1.
6. Plug the power supply into the nearby outlet and dress the power cable.
7. If the repeater is registered, ensure that the repeater connects properly with the
D100 SIP Wireless Terminal Installation and Administration Guide
provided. Install the screws 6 cm apart horizontally, in a space that has 5 cm
clearance above the screws, 2.7 cm clearance to either side and 10 cm clearance
below.
Leave the screw heads about 2 mm out from the mounting surface.
up on the ribbed section, indicated by an arrow in the following image.
image:
press on it until you hear it click.
For EU models, install the appropriate plug into the repeater power supply
adapter.
base station. If it is not registered, see Repeater registration
Overview
on page 48.
December 2012 51