Chapter 7: Factory Settings - Avaya D100 Installation And Administration Manual

Chapter 7: Factory settings

The following table lists the default factory settings for the D160 handset and the D100 base station. You
can use multiple methods to reset the base station to factory default, but the preferred method is to use
IP Office System Status Application. To determine the appropriate method to use in your situation, see
Resetting the base station to factory default
Item
Ringer Tone
Ringer Volume
Ringer Mute
Ear Speaker Volume
Hands Free Volume
Headset Volume
Range Alarm
DHCP
IP Address
Subnet Mask
Default Gateway
SIP Controller
Ping Reply
Destination Unreachable
DECT PIN ID
Administrator Password
Login ID for the Base Station Web
Management Interface
Login Password for the Base Station Web
Management Interface
System Log Level
Base DTMF Dial Output Time
D100 SIP Wireless Terminal Installation and Administration Guide
on page 80.
Handset
Tone A n/a
High n/a
Off n/a
4 n/a
4 n/a
4 n/a
On n/a
n/a Enable
n/a 192.168.1.100
n/a 255.255.0.0
n/a 192.168.1.1
n/a 192.168.1.1
n/a Enable
n/a Enable
n/a 3100
n/a 7828876
n/a d100
n/a d100
n/a Level 2
n/a 100ms
Continuous DTMF signaling is not
available.
Base station
Note:
December 2012 79