Avaya D100 Installation And Administration Manual page 20

System configuration
Lines using IP Office Manager. If only one base station is connected to the IP Office, you do
not need to configure the MAC Address.
Consider the following network configuration scenarios before you deploy the D100 terminal.
Network configuration
A single IP Office in the subnet that hosts the DHCP
server.
A single IP Office in the subnet with DHCP hosted by a
third-party server.
Multiple IP Office units with the DHCP located on an IP
Office unit where the base station is configured.
All other network configuration scenarios require static
IP addressing.
Scenario 1
You must configure the base station in IP Office Manager.
In this scenario, you can still configure the base station with static IP parameters. If you
configure static IP parameters, the base station uses and maintains these parameters after
rebooting the base station, or until you modify the IP parameters in IP Office Manager.
Procedure
1. Configure the base station in IP Office Manager:
2. Connect the base station to the subnet where the IP Office can be reached.
Scenario 2
You must use static IP addressing for the base station.
In static addressing, you must configure each base station individually in IP Office Manager
with network-specific addressing. In addition, you must configure static IP addressing on the
base station prior to installing it on the network.
Since static addressing requires DHCP to be off, the base station cannot retrieve the network
parameters from IP Office and you must turn off the DHCP client and configure the base
station's network parameters using the Base Station Web Management Interface.
20 D100 SIP Wireless Terminal Installation and Administration Guide
• Configure the SIP DECT Line as described in
page 22.
• Configure the SIP DECT Extensions as described in
extensions on page 23.
• Optional: Configure the static IP parameters for the base station. See
Configuring the static IP parameters for the base station
Double-check the values you enter as you might inadvertently lose connectivity to
the base station by providing incorrect values.
The base station downloads the configuration parameters and reboots if any
parameters were modified.
Comments? infodev@avaya.com
Scenario reference
Follow Scenario 1
Follow Scenario 1
Follow Scenario 1
Follow Scenario 2
Configuring the base station
Configuring the
on page 25.
on
December 2012