Chapter 5: Coverage Information; Out Of Range - Avaya D100 Installation And Administration Manual

Chapter 5: Coverage information

Out of range

When the handset is in an Idle state and the display reads Searching it means that the handset
cannot find its base station as it is most likely out of range. If you press the Regist soft key,
the handset enters the registration mode to register to the new base station. To complete
registration, the base station must also be put in registration mode. When the new registration
is successful the handset overwrites the previous registration information. If the new
registration is unsuccessful, nothing changes.
Use the following sections to troubleshoot various out of range scenarios.
Out of range while establishing an RF link
If you press a button but the handset cannot establish an RF link with the base station, the
handset emits an error tone and the display reads Out of Range.
Out of range while talking
If the handset does not receive a signal from the base station in approximately five seconds,
the handset terminates the call and the handset reverts to the Searching mode.
Likewise, if the base station does not receive a signal from the handset in approximately five
seconds, the base station terminates the call.
Out of range while configuring
If the handset cannot receive a signal and reverts to an out of range state while configuring
settings in the menu, the handset does not save any of the settings configured prior to
confirmation.
D100 SIP Wireless Terminal Installation and Administration Guide December 2012 53