Avaya D100 Installation And Administration Manual page 63

Reset base station
Reset the D100 base station using the following procedure on the handset. This procedure
restarts the base station but does not reset the device to any factory defaults. To reset the
device to factory defaults, see
Procedure
1. From the Administrator Setting menu, use the Next and Prev keys to navigate to
2. Press Yes to restart the base station.
Check firmware update
Use the following procedure to check for new firmware updates. You must be an administrator
to access the menu.
Procedure
1. From the Administrator Setting menu, use the Next and Prev soft keys to navigate
2. Press the Update soft key to update the firmware. Press the Back soft key to cancel
3. Press Yes to confirm the firmware update. Press No to return to the menu list.
Error information
You can access error information from the Administrator Setting menu. For more information
about error messages, see
D100 SIP Wireless Terminal Installation and Administration Guide
Use the information in the above table to manage the diagnostics. Press the Back/
Cancel soft keys or press the Off-Hook button to return to the menu list.
Factory settings
Reset Base Station and press the Select soft key.
The handset display shows a confirmation message.
Press No to return to the menu list.
to Check Firmware Update and press Select.
The base station checks for a firmware update while the handset display reads
Connecting.... After a short amount of time, the handset display shows the latest
firmware version.
the firmware update.
If the current firmware and the latest firmware are the same, the update will not
occur and the display will read The Same Version for three seconds prior to
returning to the menu list.
The base station reboots itself after updating the firmware.
Handset display reads "No Service"
on page 79.
on page 86.
Overview
December 2012 63