Table of Contents
Advertisement
Item
Description
D
Indicates marriage status. In full power mode, a green LED indicates that the projector is properly
married and encrypted content can be displayed. A red LED indicates marriage is broken and
encrypted content cannot be displayed.
E
Connects the projector to external input and output devices, such as the Christie ACT.
F
Connects the projector to a computer.
G
Resets the projector electronics. After restarting, the projector returns to its previous power mode.
H
Connects the projector to non-cinema video and graphics sources. These are single-link ports for
single-link cables and connectors. The connectors can be used together as a twin-link DVI port.
I
Connects the projector to Christie or third-party automation equipment. Utilizes the Christie-
proprietary protocol.
J
Connects the projector to 3D devices such as MasterImage or RealD.
K
Connects the projector to high-definition cinema sources. The connectors can be used together to
deliver Dual Link HD-SDI following the SMPTE 372M standard.
L
Ethernet ports to connect network-attached storage (NAS) devices.
M
eSATA ports to connect direct attached storage (DAS) devices.
N
LED status indicators:
• Power—The LED is green when the Christie IMB is on.
• FPGA Load—The LED is green when all FPGAs are successfully loaded.
• SM Run—The LED flashes green when the security manager (SM) is running correctly.
• FIPS—The LED is green when the FIPS (Federal Information Processing Standards Publications)
security status is operating correctly. If the LED is red, an error has occurred. Restart the Christie
IMB. If the LED remains red, return the Christie IMB to Christie Digital.
• OS Load—The LED is green when the Christie IMB has successfully loaded the screen management
system (SMS) operating system.
• SMS Run—The LED flashes green when the screen management system (SMS) is running correctly.
• Alarm—The LED is green when the screen management system (SMS) is operating correctly.
O
Input for multi-projector playback (Christie IMB to Christie IMB only).
P
Output for multi-projector playback.
Q
LTC output.
R
AES3 port for digital audio output.
S
Indicates the status of the regulator. A solid blue LED indicates the regulator is enabled. If the LED is
not illuminated, the regulator is not enabled.
T
• SOFTST (Software State)—Indicates the state of the software application running on the ICP.
During normal operation, this LED blinks. During start up, the LED changes from off to blinking.
• OSST (Operating System State)—Indicates the state of the ICP operating system. During normal
operation, the LED is green. During start up, the LED changes from off to green.
• FMTST (FMT FPGA State)—Indicates the state of the FMT FPGA. During normal operation, the LED
is green. When the power is turned on, the LED turns green immediately.
• ICPST (ICP FPGA State)—Indicates the configured state of the ICP FPGA. During normal
operation, the LED is green. When the power is turned on, the LED turns green immediately.
CP42LH Installation Guide
020-101373-02 Rev. 1 (06-2015)
Installation
49
Advertisement
Table of Contents
