Connect The Interlock Cables To The Laser Modules - Christie CP42LH Installation Manual

Connect the interlock cables to the laser modules

The power cables are not connected to the laser modules yet.
The Interlock cables are a straight through RS422 connection through D-Sub 9-pin connectors.
1. Attach the longest cable to the Interlock IN connector on the bottom laser module.
2. Connect the other end (B) to the projector Laser Interlock connector. See
interlock to the projector
3. Attach one end of a 30-centimeter (one-foot) interlock cable (supplied with the laser rack) to
the Interlock OUT connector on the bottom laser module.
4. Attach the other end of the cable to the Interlock IN connector on the laser module directly
above.
5. Repeat steps 3 and 4 to connect the remaining laser modules in a daisy chain.
6. Attach the 9-pin wire harness from the laser rack to the Interlock OUT connection on the top
laser module.
7. Ensure every interlock connection is populated.
CP42LH Installation Guide
020-101373-02 Rev. 1 (06-2015)
INTERLOCK IN
INTERLOCK OUT
INTERLOCK IN
INTERLOCK OUT
INTERLOCK IN
INTERLOCK OUT
INTERLOCK IN
INTERLOCK OUT
on page 47.
A
B
Installation
Connect the
34