Christie Laser Projection System Components - Christie CP42LH Installation Manual

Christie Laser Projection System components

A
B
Fiber optic bundle
A
Transmits the collected laser light to the projector.
Projector
B
Modulates light from the laser modules and passes it through a projection lens to produce the image on
the screen.
Ethernet cables
C
Connects the laser bank manager and the projector to the network.
Laser bank manager
D
Runs the laser bank control application that manages the laser modules.
Interlock cable (9-pin)
E
Carries the signal for the emergency stop, key switch, and laser modules to verify a safe connection
between the laser modules and the projector.
Interlock cable (25-pin)
F
Carries the signal for the Manual Reset button to the projector.
LM Rack (Full/Half) (rear side shown)
G
A full and a half rack are available. The LM Rack Full (shown) accommodates up to 12 laser modules, the
power distribution unit, and the Laser system network switch and equipped with a key switch and an
emergency stop for safety. The LM Rack Half accommodates up to 7 laser modules.
Laser module
H
Generates laser light for the projector.
Laser system network switch
I
Provides Ethernet connection to laser modules, laser bank manager, and projector.
Power distribution unit
J
Contains rectifiers and breakers to provide DC power to laser modules.
CP42LH Installation Guide
020-101373-02 Rev. 1 (06-2015)
E
LASER INTERLOCK
LASER RACK
D
C
F
INTERLOCK IN
Introduction
G
H
I
J
12