Table of Contents
Advertisement
2. Remove the panel and place it in the base of the laser rack.
The panels must be kept with the laser rack.
3. Continue removing adjacent panels until there is an open slot for each laser module.
Do not remove more panels than required because they ensure proper airflow throughout the
laser rack.
4. Lower the SMA covers for the laser modules:
a. Loosen the two screws securing the SMA cover with a 3mm allen key driver.
b. Slide the SMA cover down.
c. Tighten the screws to secure the SMA cover in position.
5. Keeping the laser module level, lift it out of the box.
6. Check the laser module for any possible damage that may have occurred during shipping.
Do not use a damaged laser module.
7. Slide the narrow end of the laser module into the lowest slot position of the laser rack.
Always add laser modules from the bottom up. Do not skip slots.
8. Secure the laser module to the laser rack with the four screws you removed in step 1.
9. Repeat steps 4 to 8 for the remaining laser modules.
CP42LH Installation Guide
020-101373-02 Rev. 1 (06-2015)
Installation
33
Advertisement
Table of Contents
