Table of Contents
Advertisement
General safety precautions
Failure to comply with the following results in death or serious injury.
• An incorrect power setup provides a fire and shock hazard. Do not operate the system
• Live power is a shock hazard. Only qualified service technicians are permitted to open a
Failure to comply with the following could result in death or serious injury.
• A qualified technician is required for all installations.
• The projection head must use Christie laser modules and laser rack.
• Use of the rear safety strap on the projector is mandatory to prevent the projector from
• Four or more people are required to safely lift and install the projector.
• Two or more people are required to safely lift and install a laser module.
• The extremely high brightness of the projector can cause permanent eye damage. For
• Never look directly into the projector lens.
• Concentrated light is a fire hazard. Keep hands, clothes, and all combustible material
Failure to comply with the following could result in minor or moderate injury.
• Wear protective footwear when installing the rack.
• Position all cables where they cannot contact hot surfaces or be pulled or tripped over.
The laser modules and the projector must be operated in an environment that meets the
operating range specification. For the laser modules, see
80; for the projector, see
in equipment damage.
AC power precautions
Failure to comply with the following could result in death or serious injury.
• Loose cables provide a trip or fire hazard. Position all cables where they cannot contact
• Damaged cables provide a fire hazard. Do not allow anything to rest on the power cord.
• Overloaded power outlets and extension cords provide a fire and shock hazard. Do not
• Some attachments and accessories provide a fire, shock, or personal injury hazard. Only
Only qualified service technicians are permitted to open projector enclosures and only if the
projector is disconnected from AC power. Failure to comply could result in minor or
moderate injury.
CP42LH Installation Guide
020-101373-02 Rev. 1 (06-2015)
unless certified connections, providing the recommended voltage, are used. Do not
attempt operation unless the power cord, power socket, and power plug meet the
appropriate local rating standards.
projector enclosure, and only if the AC is fully disconnected.
tipping. Secure the strap between the projector and the optional rack stand or another
structure.
protection from harmful radiation, keep all projector housings intact during operation.
away from the concentrated light beam of the projector.
Operating environment
hot surfaces, be pulled, or be tripped over.
Never operate the projector if a cable appears damaged.
overload power outlets or extension cords.
use attachments and accessories that are recommended by Christie.
Operating environment
on page 77. Failure to comply may result
Introduction
on page
13
Advertisement
Table of Contents
