Table of Contents
Advertisement
13. Press MANUAL RESET on the side of the Laser Rack or on the back of the projector.
14. Verify the status lights on the back of the projector and the front of the laser modules are
white.
The projector is armed, but the lasers are off.
Test the interlocks
Once the projector is running, ensure the safety interlocks are functioning.
Before displaying an image from the projector, test the three interlock devices. Every time
the interlock is activated, the laser modules turn off. Failure to comply could result in death
or serious injury.
Test the key switch
1. Turn the key switch on the Laser Rack off.
2. Check the status lights on the back of the projector are off.
3. Turn on the key switch.
4. Press Manual Reset on the projector.
Test the Laser Rack emergency stop
1. Press the emergency stop button on the Laser Rack.
2. Check the status lights on the back of the projector are off.
3. To release the E-stop, rotate the knob clockwise.
4. Press Manual Reset on the projector.
Test the projector emergency stop
1. Press the emergency stop button on the projector.
2. Check the status lights on the back of the projector are off.
3. To release the E-stop, rotate the knob clockwise.
4. Press Manual Reset on the projector.
Add the laser modules to the system
1. On the Laser Bank Controller, start the laser bank control application.
2. Under Available Modules, click Add IP.
3. Enter the IP address. The default is 192.168.252.1.
CP42LH Installation Guide
020-101373-02 Rev. 1 (06-2015)
Adjust the Image
54
Advertisement
Table of Contents
