Instructions For Installation Of The Base Unit - Mitsubishi Q172CPU User Manual

4 INSTALLATION AND WIRING

4.1.2 Instructions for installation of the base unit

Q35B
W 245 (9.65)
Ws 224.5 (8.84)
H
Hs
Top of panel or wiring duct
20mm
(0.79inch)
5mm
(Note-1)
(0.20inch)
or more
(Note-1) : When the extension cable is connected without removing the adjacent module: 20mm (0.79 inch) or more.
(Note-2) : Q173CPU/Q172CPU : 50mm (1.97 inch) or more
(Note-3) : Q173CPUN(-T)/Q172CPUN(-T) : 123mm (4.84 inch)
Install the Motion controller module to a panel, etc. , considering enough about
operability, maintainability and environmental resistance.
(1) Fitting dimensions
Fitting dimensions of each base unit are as follows:
4 fixing screw (M4 14)
5V
56
CPU I/00
POWER
F6
Q38B
328 (12.91)
308 (12.13)
(2) Motion controller installation position
For enhanced ventilation and ease of module replacement, leave the following
space between the module top/bottom and structure/parts.
The wind blows lies
Motion CPU module
Q173CPUN(-T)/Q172CPUN(-T)(Height of a wiring duct is 50mm (1.97 inch) or more) :
40mm (1.57 inch) or more
I/01 I/02 I/03 I/04
Ws
W
Q312B Q65B
439 (17.28) 245 (9.65)
419 (16.50) 222.5 (8.76)
98 (3.86)
80 (3.15)
30mm
(Note-2)
(1.18inch)
or more
Control
panel
100mm
(3.94inch)
or more
5mm
(0.20inch)
or more
4 - 3
I/05 I/06 I/07 I/08 I/09
Q68B
328 (12.91)
306 (12.05)
Base unit
Motion
controller
98mm
(Note-3)
(3.86inch)
I/10 I/11
0358
Q612B
439 (17.28)
417 (16.42)
[Unit: mm (inch)]
Door
100mm
(3.94inch)
or more