GE C30 Instruction Manual page 117

Ur series
Hide thumbs Also See for C30:
Table of Contents

Advertisement

4 HUMAN INTERFACES
2.
Bend the tab at the center of the tool tail as shown below.
The following procedure describes how to remove the LED labels from the C30 enhanced front panel and insert the custom
labels.
1.
Use the knife to lift the LED label and slide the label tool underneath. Make sure the bent tabs are pointing away from
the relay.
2.
Slide the label tool under the LED label until the tabs snap out as shown below. This will attach the label tool to the LED
label.
GE Multilin
C30 Controller System
4.3 FACEPLATE INTERFACE
4-19
4

Advertisement

Table of Contents
loading

Table of Contents