GE C30 Instruction Manual page 157

5 SETTINGS
The breaker configuration settings are shown below. Changes to these values will not take effect until the UR is restarted:

PATH: SETTINGS PRODUCT SETUP
 XCBR
 CONFIGURATION
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
The setting represents the breaker operating counter. As breakers operate by opening and closing, the
CLEAR XCBR1 OpCnt
XCBR operating counter status attribute (OpCnt) increments with every operation. Frequent breaker operation may result
in very large OpCnt values over time. This setting allows the OpCnt to be reset to "0" for XCBR1.
GE Multilin
 
COMMUNICATIONS IEC 61850 PROTOCOL
XCBR1 ST.LOC OPERAND
Off
XCBR2 ST.LOC OPERAND
Off
XCBR3 ST.LOC OPERAND
Off
↓
XCBR6 ST.LOC OPERAND
Off
CLEAR XCBR1 OpCnt:
No
CLEAR XCBR2 OpCnt:
No
CLEAR XCBR3 OpCnt:
No
↓
CLEAR XCBR6 OpCnt:
No
C30 Controller System
5.2 PRODUCT SETUP

XCBR CONFIGURATION
Range: FlexLogic™ operand
Range: FlexLogic™ operand
Range: FlexLogic™ operand
Range: FlexLogic™ operand
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
5
5-31