Filament Installation - Cubicon Single Plus User Manual

5-3. Filament installation

① You can open by pushing back a spool door handle of
the printer body.
③ Open the top door and push in the filament until it
comes out of Teflon tube entrance
* Filament spool has its own direction
side is visible from outside)
*Any interruption between filament bar and the spool, in the process of the filament spool installation, may
cause the printer malfunction as it raise the problem in a filament supply.
which causes interruption to rotation in the spool insert process.
included silica gel from inside spool.
* A teflon tube is the channel from the filament spool to the
tube breaking, or tube twisting may occur and it may cause abnormal filament operation and malfunction as
the teflon tube length is optimised to the printer. Do not break, cut or pull installed teflon tube with extreme
power.
② Slowly release the filament from filament spool and
push the filament into filament insert hole
rotation direction
④ Insert the filament spool into filament bar and fix spool by
closing the spool door pressing handle until you hear clicker.
(Install the spool, make sure that company logo or the product sticker
extruder.
14
CUBICON Single Plus
Make sure to remove an obstacle,
Make sure to remove a spool package
if the tube is pulled with exteme power,
User Manual
* be careful of the