Table of Contents
Advertisement
the problem by separating the removable Extruder. Especially in case of a filament with a low
printing temperature, the tangling problem inside of the Extruder may occur easily. The tangling
problem may be improved by using the device after lowering the temperature inside of the device.
●
Check whether the removable Extruder is correctly mounted. If there is any problem with the
mounting, an error message may appear on the LCD screen.
●
Check whether the temperature conditions of the filament that is used and the Extruder of the
printer are appropriate.
●
Replace the nozzle if it is damaged. A nozzle is a consumable item. Replace it by using a
warranty service (→
●
The nozzle may get clogged due to the internal pollution of the Extruder. It is recommended to
regularly manage the Extruder. (→
Data in a USB Drive Can't Be Viewed.
●
Style Plus-A15 only supports FAT32 and NTFS file system formats.
●
Style Plus-A15 only supports CFB file format that has been created in Cubicreator. Check
whether the file exists normally through a PC.
Data in a USB Drive Can't Be Printed.
●
Check whether the file that has been selected is G-Code with *.cfb file extension.
●
Style Plus-A15 can only use the G-Code (*.cfb) file that has been sliced by using Cubicreator.
G-Code file that some other slicing programs have been used can't be printed, and it can cause
damage to the device.
●
The data in the USB drive may be damaged. Create G-Code file again and use it.
●
If a problem occurs in the process of copying the file to the memory after slicing using
Cubicreator, it may not be printed. Check whether the G-Code file is normal using Cubicreator. If
the printing path that can be viewed through G-Code is shown to be an abnormal path, G-Code is
invalid.
●
Check whether there is a problem in the slicing by opening the original 3D model in Cubicreator
and check whether it is normal during the conversion of the G-Code. And then, check whether
there is a problem in the 3D model using a separate 3D model inspection program.
●
There may be a problem in saving the data in the USB drive due to a security program in the PC
of a user or a virus. Take a necessary action after checking the problem and retry.
When Printing, the Printing Doesn't Progress as Auto Leveling Fails.
●
Check whether a vibration of the surrounding environment affects the device during Auto
Leveling. If the vibration around the device reaches the device, the Auto Level may fail.
●
Before starting the printing, the printer proceeds with the Auto Level of the bed. If Auto Leveling
fails due to a certain reason (it is retried a few time automatically), the printer stops printing.
CUBICON Style Plus-A15 Series
R efer to Replacing the Nozzle.)
R efer to Management of the Extruder.)
65
U ser Manual
Advertisement
Table of Contents
