Installation And Printing Preparation; Unpacking - Cubicon Single Plus User Manual

5. Installation and printing preparation

5-1. Unpacking

① Take out the product from plastic packing.
* Considering volume and weight of the printer, at least two persons shall handle the printer.
* Release the printer from plastic packing and then take out only the printer without plastic packing as plastic
material may slip in the process of taking out.
③ Open the front door and take out inside packing
material, accessories and check out if any material is
missing.
* The driving part is fixed only with packing material without using cable tie to prevent potential problems when
the printer is operating with it. Please, be cafeful not to damage the part when removing the internal packing
material.
② Move the product to installation spot.
④ Open the top door and take out extruder fixture packing material.
sure not to break the extruder driving cable or a Teflon.
12
CUBICON Single Plus User Manual
Make