Unpacking And Installation - Cubicon Style 3DP-210F Quick Start Manual

Be careful when unpacking and installing the product, as excessive force or ripping can
damage the content.
Unpacking
Pay attention not to damage the Drive cable of extruder or Teflon tube being pulled, bent,
stabbed to affect the operation of extruder and filament feeding.
① Place the package on the floor and
remove the side packing materials
including the accessories.
Pay attention not to drop the packing
materials including the accessories.
② Pull the product out of the vinyl bag and
move to its installation place.
Hold the product and take it out of the
box. Holding the vinyl and taking it out
will damage the product.
③ Remove the inside and outside tape. (There will be taped except for the place in picture).
Copyright Reserved HyVISION System Inc.
This document is Quick Start Guide (151001,En). To improve quality of product, this could be revised without
prior notification or consent.
HyVISION System is not liable for any losses resulted from the use of the document or any errors or offering.

Unpacking and Installation (1/4)

8