Device List And Connection; Review The Device List; Connect/Disconnect An Active Device - AT&T TL96456 Complete User's Manual

Bluetooth
Bluetooth setup

Device list and connection

Up to four devices can be paired to the telephone base. All paired devices are
shown on the device list. To use a paired device, it must be connected and in
an active slot (D1: or D2:) on the device list. Both active devices can be on a
call at a time.
Once you have paired a device with the telephone base, you do not need
to repeat the pairing procedure again unless you delete the device from the
device list.
NOTE: When connecting a Bluetooth device to the device list, all connected devices will be
temporarily disconnected until the procedure is complete. It may take up to two minutes
to reconnect.

Review the device list

MENU
1. Press
2. Press or
CID
press SELECT.
3. Press or
CID
press SELECT.

Connect/disconnect an active device

While in the active device list, you may connect or disconnect your
active device.
1. Press MENU
2. Press or
CID
press SELECT.
3. Press or
CID
press SELECT.
4. Press or
CID
5. Press or
CID
applicable), then press
Device connected/Device disconnected. You hear a confirmation tone.
NOTE: When your active device is connected, you are prompted to select Disconnect. When
your active device is disconnected, you are prompted to select Connect.
on the telephone base in idle mode.
to highlight Bluetooth, then
DIR
to highlight Device list, then
DIR
on the telephone base in idle mode.
to highlight Bluetooth, then
DIR
to highlight Device list, then
DIR
to highlight a device, then press OPTION.
DIR
to highlight Connect/Disconnect (whichever is
DIR
SELECT to confirm. The telephone base displays
25
DEVICE LIST
D1:Cel l Phone X
D2:Headset Y
Cel l Phone Z
BACK OPTION
Cel l Phone X
Disconnect
Remove
BACK SELECT