Device List And Connection; Review The Device List; Connect/Disconnect An Active; Device - AT&T BL103-1K Complete User's Manual

Bluetooth
Bluetooth setup

Device list and connection

Up to 2 devices can be paired to the telephone base. All paired devices are
shown on the device list. To use a paired device, it must be connected. Both
Bluetooth enabled devices can be used on a cell call at a time.
Once you have paired a device with the telephone base, you do not need to
repeat the pairing procedure again unless you delete the device from the
device list.
Note: When connecting a Bluetooth device to the device list, all connected devices will be temporarily
disconnected until the procedure is complete. It may take up to two minutes to reconnect.

Review the device list

1. Press MENU/
telephone is not in use.
2. Press or
CID
/SELECT.
press
MENU
/SELECT again to select Device list.
3. Press
MENU
Connect/disconnect an active device
While in the device list menu, you may connect or disconnect your
active device.
1. Press MENU/
2. Press or
CID
3. Press or
CID
4. Press or
CID
5. Press or
CID
applicable), then press
connected/Device disconnected. You hear a confirmation tone.
Note: When your active device is connected, you are prompted to select Disconnect. When your active device is
disconnected, you are prompted to select Connect.
on the telephone base when the
SELECT
to highlight Bluetooth, then
DIR
on the telephone base in idle mode.
SELECT
to highlight Bluetooth, then press
DIR
to highlight Device list, then press
DIR
to highlight a device, then press
DIR
to highlight Connect/Disconnect (whichever is
DIR
/SELECT . The telephone base displays Device
MENU
27
Intercom
>Bluetooth
BLUETOOTH
>Device list
/SELECT.
MENU
/SELECT.
MENU
/SELECT.
MENU