Remote Access Code - AT&T TL96456 Complete User's Manual

Answering system
Answering system settings

Remote access code

To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access
code is 19.
To change the remote access code:
1. Press MENU
2. Press or
CID
SELECT .
3. Press or
CID
SELECT
.
4. Press or
CID
SELECT
.
5. Use the dialing keys to enter a two-digit number.
Press /DELETE on the handset or X/DELETE on the
MUTE
telephone base to erase a digit.
6. Press SAVE to confirm. You hear a confirmation tone.
in idle mode.
to highlight Answering sys, then press
DIR
to highlight Ans sys setup, then press
DIR
to highlight Remote code, then press
DIR
115
ANS SYS SETUP
Cal l screening
# of rings
Remote code
BACK SELECT
REMOTE CODE
19
BACK SAVE
ANSWERING SYS
Cal l screening
# of rings
Remote code
BACK SELECT
REMOTE CODE
19
BACK SAVE