AT&T TL96456 Complete User's Manual page 85

Multiple handset use
Push-to-talk (PTT)
Using the telephone base:
1. There are a few ways to begin a PTT call to a single handset. When the
telephone base is not in use:
• If you have one handset, press and hold PTT/
If you have more than one handset, press PTT/
•
 Use the dialing keys to enter the destination handset number (1-9 for
handsets 1-9, TONE
11 or TONE
-OR-
 Press
SELECT
Your telephone base displays Connecting to HANDSET X... (HANDSET
represents the handset name, X represents the destination handset number)
for a few seconds. When the connection is made, both the telephone base
and the destination handset display Press and hold [PTT] to talk and beep
once.
2. Press and hold PTT/
towards the telephone base. Your voice is broadcast to the destination
handset. While you are speaking, the telephone base displays PTT To
HANDSET X (X represents the destination handset number).
Release PTT/
3.
screens show Press and hold [PTT] to talk, then you can press and hold
PTT/ to continue speaking or the destination handsets can respond (see
FLASH
Answer a PTT call on page 81).
4. To end the PTT call, press CANCEL or END. The telephone base shows Push
to talk Ended for a few seconds.
NOTE: After PTT/
presses PTT/
FLASH
and 0 for handset 10, TONE
and 2 for handset 12).
or to scroll to the destination device, then press
CID DIR
or PTT/ .
FLASH
. A chirp indicates your microphone is on. Speak
FLASH
after speaking. Both devices beep once again and the
FLASH
is released, the PTT call remains open for a short time. If no one
FLASH
within 10 seconds, the PTT call ends automatically.
FLASH
FLASH
78
in idle mode.
in idle mode:
and 1 for handset