Auto Connection; Bluetooth Connection From Idle Mode - AT&T TL96456 Complete User's Manual

Bluetooth
Bluetooth setup
The screen displays Adding Headset Y when the base is
connecting to your headset (Headset Y represents the
device name of your Bluetooth headset).
When a device is successfully connected, the telephone
base displays Headset Y is added and connected to
base. and the corresponding status icon
represents the device name of your Bluetooth headset). You
hear a confirmation tone. The CELL 2/HEADSET light on the
telephone base turns on.
If you have trouble pairing your headset, it may not be compatible
with your TL96276/TL96456. Check the Bluetooth compatibility list at
www.telephones.att.com/bluetooth
NOTES:
• The pairing process may take up to one minute. If the pairing process fails, try again.
• When a connected headset is charging, it may disconnect from the telephone base and the
CELL 2/HEADSET light on the telephone base turns off. For some headset models, you may
need to turn on the headset and reconnect it to the telephone base again.

Auto connection

When an active device moves within Bluetooth range of the telephone base,
or is turned on within range, the telephone base tries to connect to the device.
When the device moves out of range, it is disconnected. Your device might
make a connect or disconnect sound.
A connected device could also be disconnected by:
• Turning off the Bluetooth device.
• Turning off the Bluetooth feature of the device.
Disconnecting through the telephone base Device list. If you disconnect
•
through the Device list, the telephone base will not attempt to reconnect
until your device is moved out of range and then moves back in range again.

Bluetooth connection from idle mode

When you have active devices that are not connected,
idle handsets and telephone base. Press
active device. When there are two active devices, the handset will prompt you
to choose one before connection.
2 (Headset Y
.
CONNECT
to start connecting an
24
Adding
Headset Y
Headset Y
is added
and connected
to base.
CONNECT appears on