Ptt Call To Multiple Devices - AT&T TL96456 Complete User's Manual

Multiple handset use
Push-to-talk (PTT)

PTT call to multiple devices

When there are multiple handsets registered to the phone system, PTT supports
one-to-group calls. PTT supports a maximum of one-to-four calls when two to
five handsets are registered, and a maximum of one-to-three calls when six or
more handsets are registered. The first four registered handsets will be eligible
to use this feature. Other handsets can only use PTT for one-to-one calls.
To call multiple devices:
Using a handset:
1. You have two ways to call multiple devices. When the handset is not in use:
• Press and hold PUSH TO TALK until the handset shows Connecting
to group....
-OR-
• Press PUSH TO TALK in idle mode. Press
then press
to group....
When the connection is made, the initiating handset and all destination
devices display Press and hold [PTT] to talk and beep once.
Press and hold PUSH TO TALK on your handset. A chirp indicates your
2.
microphone is on. Speak towards the handset. Your voice is broadcast to
all devices.
Release PUSH TO TALK after speaking. All devices beep once again and
3.
the screens show Press and hold [PTT] to talk, then you can press and hold
PUSH TO TALK to continue speaking or the destination devices can respond
(see Answer a PTT call on page 81).
4. To end the PTT call, press
the telephone base or charger. The handset shows Push to talk Ended for a
few seconds.
NOTE: After PUSH TO TALK is released, the PTT call remains open for a short time. If no one
presses PUSH TO TALK within 10 seconds, the PTT call ends automatically.
SELECT or PUSH TO TALK. Your handset shows Connecting
OFF/ or END, or place the handset in
CANCEL
79
or to highlight Group,
CID DIR