Installing the device
4.
Repeat Step 1 to Step 3 to attach the left front bracket to the left front rack rail and tighten all 10-32 x 5/8 in. screws to a
torque of 25 in-lb (29 cm-kg).
Four-post rack mount installation
Kits for four-post rack mounting are not included in the shipping carton and must be ordered separately.
NOTE
Use the following procedure when installing the ICX 6610 in a four-post rack cabinet. For two-post cabinets, follow the
procedures in the section
Remove the rack mount kit from the shipping carton. The kit contains the following:
•
Two mounting brackets
•
Two pairs of extension brackets. Use the shorter pair for racks that are up to 27 inches deep. Use the longer pair for racks up to
32 inches deep.
•
Thirty-two 8-32 x 3/8 in., panhead Phillips screws with patchlocks
•
Eight 10-32 x 5/8 in., panhead Phillips screws
•
Eight 32-10 retainer nuts (for square-hole rack rails)
•
Eight 32-10 retainer nuts (for round-hole rack rails)
36
Two-post rack mount installation
on page 31.
Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003620-03