Table of Contents
Advertisement
TABLE 10 Cable length summary (continued)
Cable type
100Base-FX-IR
SMF
100Base-FX-LR
SMF
40GBase
Copper
40GBase-SR4
MMF
Installation location
Devices can be mounted in a standard 19-inch equipment rack or on a flat surface.
The site should meet the following requirements:
•
Maintain the operating environment as specified in the section
•
Operate at temperatures within 0° to 45° C (32° to 113° F) and humidity levels within 5% to 95%, non-condensing.
•
Allow a minimum of 7.62 cm (3 in.) of space between the front and the back of the device and walls or other obstructions for
proper airflow.
•
Allow at least 7.62 cm (3 in.) of space at the front and back of the device for the twisted-pair, fiber-optic, and power cabling.
•
The site should be accessible for installing, cabling, and maintaining the devices.
•
Allow the status LEDs to be clearly visible.
•
Allow for twisted-pair cable to be routed away from power lines, fluorescent lighting fixtures, and other sources of electrical
interference, such as radios and transmitters.
•
For a unit with AC power, allow for the unit to be connected to a separate grounded power outlet that provides 100 to 240
VAC, 50 to 60 Hz, is within 2 m (6.6 feet) of each device, and is powered from an independent circuit breaker. As with any
equipment, a filter or surge suppressor is recommended.
•
For a unit with DC power, allow for the unit to be connected to a separate grounded power outlet that provides 40 to 72 VDC, is
within 2 m (6.6 feet) of each device, and is powered from an independent circuit breaker. As with any equipment, a filter or surge
suppressor is recommended.
•
Some combinations of intake and exhaust airflow may not be compatible with your environment. Consult your fan and power
supply module field-replaceable unit (FRU) kit to determine the correct configuration.
•
For a four-post rail mount configuration, order the appropriate mounting kit and refer to the kit documentation.
Installing the device
You can install the device on a desktop or in an equipment rack.
DANGER
Make sure the rack housing the device is adequately secured to prevent it from becoming unstable or falling over.
Desktop installation
Use the following steps to install the ICX 6610 on a desktop or other flat surface.
Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003620-03
Connector type
Core diameter
(microns)
9 µ
LC
9 µ
LC
QSFP+
n/a
50 μ
MTP (MPO) 1×8 or
1×12 ribbon
connector
Environmental requirements
Modal bandwidth
Range
(MHz*km)
n/a
15 km
n/a
40 km
n/a
1 and 5 m
2000 MHz*km
100 m
4700 MHz*km
150 m
on page 86.
Installing the device
29
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
