Installing The 1U And 2U Fixed-Mount Rack Kit For Four-Post Racks (Xbr-R000162); Time And Items Required - Brocade Communications Systems 300 Hardware Installation Manual

3. Tighten all the screws to a torque of 9 in-lbs (10 cm-kgs).
FIGURE 8 Attaching the rear brackets to the device
1. Screw, 8-32 x 5/16-in., panhead Phillips
Installing the 1U and 2U Fixed-Mount Rack Kit for
Four-Post Racks (XBR-R000162)
Use the following instructions to install a fixed-port device in a fixed-mount configuration using the 1U and 2U Fixed-Mount Rack Kit for
Four-Post Racks (XBR-R000162).
Observe the following when mounting this device:
• Two people are required to install the device in a rack. One person holds the device, while the other secures the device to the
rack.
• Use Electronic Industries Association (EIA) standard racks.
• Before mounting your device, review any specific installation and facility requirements in this Hardware Installation Guide.
• Hardware devices illustrated in these procedures are only for reference and may not depict the device you are installing into the
rack.

Time and items required

Allow 15 to 30 minutes to complete the installation procedure.
The following items are required to install a device using the 1U and 2U Fixed-Mount Rack Kit for Four-Post Racks (XBR-R000162).
• #2 Phillips torque screwdriver
• 1/4-inch slotted-blade torque screwdriver
Brocade 300 Hardware Installation Guide
53-1000862-12

Installing the 1U and 2U Fixed-Mount Rack Kit for Four-Post Racks (XBR-R000162)

23