Danger - Brocade Communications Systems ICX 6610 Installation Manual

Installing or replacing fan trays
FIGURE 49 Installing a fan tray on an ICX 6610 (1000W)
Perform the following steps to install a fan tray in the switch.
NOTE
It is recommended that you wear an ESD wrist strap during installation.

DANGER

For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.
1. Remove the installed fan tray from the slot by removing the retaining screw with a Phillips screwdriver.
2. Before opening the package that contains the new fan tray, touch the bag to the switch casing to discharge any potential static
electricity.
3. Remove the fan tray from the anti-static shielded bag.
4. Holding the fan tray level, guide it into the carrier rails on each side and gently push it all the way into the slot, ensuring that it
firmly engages with the connector.
5. When you are sure the fan tray has properly engaged the connector, tighten the retainer screw to secure the fan tray in the slot.
NOTE
The fans are controlled automatically by the device.
62
Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003620-03