Table of Contents
Advertisement
Installing the 8U Chassis 27-31-Inch Rail Rack Kit for Four-Post Racks (XBR-DCX4S-0120)
6.
Secure the device to the rack using six 10-32 screws with square-cone washers, three screws for each mounting bracket
attached to the device. Refer to the following figure. Tighten the screws to 32 in-lb (36.86 cm-kg)
NOTE
Screws, clip nuts, and retainer nuts for mounting the device to the equipment rack are located in the device hardware
accessory kit.
FIGURE 22 Device installed in mid-mount saddle
1.
10-32 screws with square-cone washers (6)
NOTE
For rails with round holes, use the clip nuts on the rack rails for securing 10-32 screws. For rails with square holes,
use the retainer nuts (refer to
7.
Reinstall the door. Refer to procedures for removing and replacing the device door in this guide.
Installing the 8U Chassis 27-31-Inch Rail Rack Kit for
Four-Post Racks (XBR-DCX4S-0120)
Use the following instructions to install the device in a rack using the 8U Chassis 27-31 Inch Rail Rack Kit for Four-Post Racks (XBR-
DCX4S-0120).
56
Figure 16
on page 50). Also refer to
Figure 19
on page 53.
Brocade X6-4 Director Hardware Installation Guide
53-1004106-07
Advertisement
Table of Contents
