Installing An Ac Power Supply - Brocade Communications Systems ICX 6610 Installation Manual

Power supplies for the Brocade ICX 6610
CAUTION
Ensure that the airflow direction of the power supply unit matches that of the installed fan tray. The power supplies and fan
trays are clearly labeled with either a green arrow with an "E", or an orange arrow with an "I."
You can run the device with one or two power supply units installed. If you install a second power supply, it is recommended to install a
second fan tray also.

Installing an AC power supply

You need a #2 Phillips screwdriver and a flat-head screwdriver for installation.
Brocade recommends using an ESD wrist strap during installation.
FIGURE 44 Installing an AC power supply unit
Use the following steps to install an AC power supply in the switch.
1. If replacing a power supply, remove the previously installed power supply from the appropriate slot by removing the two screws
with a flat-head screwdriver.
2. If installing a new power supply into a slot covered with a filler panel:
a) Using a Phillips screwdriver, unscrew the screws on the filler panel.
b) Remove the filler panel.
3. Before opening the package that contains the power supply, touch the bag to the switch casing to discharge any potential static
electricity.
4. Remove the power supply from the anti-static shielded bag.
5. Holding the power supply level, guide it into the carrier rails on each side and gently push it all the way into the slot, ensuring
that it firmly engages with the connector.
56
Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003620-03