Cabling A Fiber-Optic Module; Cleaning The Fiber-Optic Connectors - Brocade Communications Systems ICX 6610 Installation Manual

Cabling a fiber-optic module

4. Grasp the bail latch and pull the copper or fiber-optic module out of the port.
FIGURE 55 Remove fiber-optic module
5. Store the copper or fiber-optic module in a safe, static-free place or in an anti-static bag.
6. Install a new copper or fiber-optic module in the port.

Cabling a fiber-optic module

For instructions on cabling a fiber-optic module, refer to the section

Cleaning the fiber-optic connectors

For instructions on cleaning a fiber-optic module, refer to the section
84
Cabling a fiber-optic transceiver

Cleaning the fiber-optic connectors

Brocade ICX 6610 Stackable Switch Hardware Installation Guide
on page 71.
on page 72.
53-1003620-03