Power Supplies - Brocade Communications Systems ICX 6610 Installation Manual

Power supplies

Power supplies

The device has two power supply receptacles on the rear panel. Each device ships with one AC power supply installed. Each power
supply has one standard power receptacle for the AC power cable. A secondary AC power supply can be installed to provide backup
power in case of a failure and for load-balancing when both power supplies are operational. AC power supplies can be hot swapped.
DC power supplies are available for the device. A secondary DC power supply can be installed for backup and load-balancing when both
power supplies are operational. DC power supplies can also be hot swapped.
NOTE
AC and DC power supplies cannot be installed and used in the same device. Mismatched power supplies in the same device
cause continual reboot on power up.
NOTE
Forward and reverse airflow power supplies cannot be installed in the same
device.
For instructions on installing and replacing a power supply refer to
information on LED status refer to Power status LEDs table in the section
FIGURE 18 ICX 6610 AC power supply receptacle on 48-port models
1. AC power receptacle
22
Installing and replacing a power supply unit
Port, system, and power status LEDs
Brocade ICX 6610 Stackable Switch Hardware Installation Guide
on page 55 section. For
on page 18.
53-1003620-03