Brocade Communications Systems ICX 6610 Installation Manual page 58

Power supplies for the Brocade ICX 6610
CAUTION
For a DC system, use grounding wire of at least 12 American Wire Gauge (AWG). The grounding wire should be attached to
the DC input connector the other end connects to the building ground.
NOTE
AC and DC power supplies cannot be installed and used in the same device. Mismatched power supplies in the same device
cause continual reboot on power up.
FIGURE 45 DC power supply unit
You need a #2 Phillips screwdriver and a flat-head screwdriver for installation.
Brocade recommends using an ESD wrist strap during installation.
DANGER
For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.
1. Ensure the power on the DC power supply is switched off.
58
Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003620-03