Lifting Precautions; Power Precautions - Brocade Communications Systems ICX 6610 Installation Manual

CAUTION
Do not install the device in an environment where the operating ambient temperature might exceed 45°C (113°F).
CAUTION
Make sure the airflow around the front, sides, and back of the device is not
restricted.
CAUTION
Never leave tools inside the chassis.
DANGER
Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.

Lifting precautions

DANGER
Make sure the rack housing the device is adequately secured to prevent it from becoming unstable or falling over.
DANGER
Mount the devices you install in a rack as low as possible. Place the heaviest device at the bottom and progressively place
lighter devices above.

Power precautions

CAUTION
Use a separate branch circuit for each power cord, which provides redundancy in case one of the circuits fails.
DANGER
To avoid high voltage shock, do not open the device while the power is on.
CAUTION
Ensure that the device does not overload the power circuits, wiring, and over-current protection. To determine the possibility
of overloading the supply circuits, add the ampere (amp) ratings of all devices installed on the same circuit as the device.
Compare this total with the rating limit for the circuit. The maximum ampere ratings are usually printed on the devices near
the input power connectors.
DANGER
Remove both power cords before servicing.
DANGER
Disconnect the power cord from all power sources to completely remove power from the device.
CAUTION
Before plugging a cable into to any port, be sure to discharge the voltage stored on the cable by touching the electrical
contacts to ground surface.
Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003620-03
Installation precautions
27