Table of Contents
Advertisement
5.
Use a lift to raise the device to the correct level. Use two people, one to operate the lift and the other to secure the device on the
lift.
CAUTION
Do not attempt to lift or support the chassis by the logo bezel attached over the port-side air vents.
NOTE
Orient the device on the lift so that you can slide it into correct side of rack to provide cool air intake. Fans and power
supply FRUs in this device have a green "E" or "I" symbol on the FRU faceplate. An "E" indicates that the FRU pulls air
from the port side of the device and exhausts out the nonport side. An "I" indicates that the FRU pulls air from the
nonport side of the device and exhausts out the nonport side. Fans and power supplies must have the same airflow
indicator. Be sure that you are pulling cool air into the air intake side of the device. For more details, refer to
power supply airflow
6.
If applicable, lock the wheels of the lift.
7.
Install the applicable rack mount kit in your equipment rack and mount the device using the rack mount kit's installation
instructions.
NOTE
When installing the device into the rack, use one person on each side of the device to gently slide it onto the final
installation surface and ensure that it remains supported during the transfer.
8.
Reinstall the cable management comb if you removed it.
9.
Reinstall the chassis door. The door must be installed to meet EMI compliance.
Installing the 14U Rack Mount Kit for Four-Post
Racks (XBR-DCX-0120 and XBR-DCX-0152)
Use the following instructions to install a modular device in a 19-in. (48.3 cm) EIA rack using the 14U Rack Mount Kit for Four-Post
Racks (XBR-DCX-0120 and XBR-DCX-0152).
Two rack-mount kits are available.
•
XBR-DCX-0120 - Contains shelf brackets that telescope from 27 in. (68.58 cm) to 31 in. (78.74 cm) to fit the majority of
racks.
•
XBR-DCX-0152 - Contains 22 in. (55.88 cm) fixed shelf brackets that adjust to 27 in. (68.58 cm).
Observe the following when mounting this device:
•
Use Electronic Industries Association (EIA) standard racks. Ensure that the space in the 19-in. (48.3 cm) EIA rack is 14U high.
•
Verify that the additional weight of the chassis does not exceed the weight limits of the rack.
•
Before mounting your device, review any specific installation and facility requirements in this Hardware Installation Guide.
•
Hardware devices illustrated in these procedures are only for reference and may not depict the device you are installing into the
rack.
Time and items required
Allow approximately one hour to unpack and install a device in a rack.
Brocade X6-8 Director Hardware Installation Guide
53-1004105-07
Installing the 14U Rack Mount Kit for Four-Post Racks (XBR-DCX-0120 and XBR-DCX-0152)
on page 176.
Fan and
31
Advertisement
Table of Contents
