Mini Physical Interface Module Port Descriptions - Juniper SSG 20 Hardware Installation And Configuration Manual

SSG 20 Hardware Installation and Configuration Guide

Mini Physical Interface Module Port Descriptions

6
Front Panel
See "Connectors" on page III for the RJ-45 connector pinouts.
Each mini physical interface module (PIM) supported on a device has the following
components:
One cable connector port—Accepts a network media connector. Figure 3 shows
the available mini PIMs. You can install up to two mini PIMs in a device.
Figure 3: Mini PIMs on the SSG 20
ADSL 2 /2 +
SYNC
TX/RX
ADSL 2 /2 +
SYNC
TX/RX
ISDN (BRI )
Channel B 1
Channel B 2
T1
ALARM
LOOP BACK
CD
E1
ALARM
LOOP BACK
CD
V .9 2
TX/RX
CD
Two to three status LEDs—Indicates port status. Table 4 describes the meaning
of the LED states.
ADSL2/2+ Annex B
ADSL2/2+ Annex A
ISDN BRI
T1
E1
V.92