Pbyp (Picture By Picture); Pip (Picture In Picture) - Christie LW502 User Manual

PbyP (Picture by Picture) / PIP (Picture in Picture)
The PbyP / PIP is a function for displaying two different picture signals on a
screen that is separated into main and sub areas for each signal.
MYBUTTON
INPUT
1 2
PbyP
MYBUTTON
INPUT 1 ASPECT 2 PbyP AUTO FREEZE
button
ASPECT PbyP AUTO FREEZE
MAGNIFY FOCUS ZOOM VOLUME
+ + +
ON
- - -
OFF
PAGE
UP GEOMETRY PICTURE MUTE
MAGNIFY FOCUS ZOOM VOLUME
+ +
DOWN INTERACTIVE NETWORK BLANK
ON
ESC MENU
ENTER
OSD MSG RESET
-
-
OFF
Press the PbyP button on the remote control. This activates the PbyP mode.
PAGE
UP GEOMETRY PICTURE MUTE
Then, press the PbyP button again. The projector goes into PIP mode. The
screen displayed before the PbyP button was pressed is displayed as the main
DOWN INTERACTIVE NETWORK BLANK
area. Most of operations are effective for the main area only. Only outputs the
audio input signal paired with the picture input signal for the main area.
ESC MENU
To quit the PIP mode, press the PbyP button again.
ENTER
NOTE
• If the LAN port is selected when the PbyP button is pressed, input
from other port is displayed on the main area.
OSD MSG RESET
• When in the PbyP / PIP mode, use the MENU button on the remote control or
▲/▼ buttons on the control panel to display the OSD menu.
• Some functions that cannot be used when in the PbyP / PIP mode.
• A message is displayed when buttons that cannot be used are pressed (111).
However, messages are not displayed for some unusable buttons.
• The functions on the OSD menu that cannot be used are displayed in gray
and cannot be selected.
(continued on next page)
LW502/LWU502 User's Manual - Operating Guide
020-001057-01 Rev. 1 (06-2016)
+
Normal mode
-
main sub
ð
area area
PbyP mode
Operating
main
area
ð
PIP mode
sub area
47