Maintenance; Replacing The Lamp - Christie LW502 User Manual

Maintenance

Replacing the lamp

A lamp has finite product life. Using the lamp for long periods of time could cause the
pictures to darken or the color tone to turn poor. Each lamp has a different lifetime,
and some may burst or burn out soon after you start using them.
New lamp preparation and early replacement are recommended. To prepare a new
lamp, contact your dealer and indicate the lamp type number.
Type number : 003-005852-01 (
Replacing the lamp
1.
Turn the projector off, and unplug the power cord.
Allow the projector to cool for at least 45 minutes.
2.
Prepare a new lamp. If the projector is mounted with
specified mounting accessories, or if the lamp has broken,
also ask the dealer to replace the lamp.
If replacing the lamp by yourself, complete the following
procedure.
3.
Loosen the screw (marked by arrow) of the lamp cover and
then slide down and lift the lamp cover to remove it.
4.
Loosen the three screws (marked by arrow) of the
lamp, and slowly pull the lamp out by the handles.
Never loosen any other screws.
5.
Insert the new lamp, and firmly retighten the three
screws of the lamp loosened in the previous step to lock
it in place.
6.
While putting the interlocking parts of the lamp cover and
the projector together, slide the lamp cover back in place.
Firmly fasten the screw of the lamp cover.
7.
Turn the projector on and reset the lamp hours using
the LAMP HOURS item in the SETUP menu.
(1) Press the MENU button to display a menu.
(2) Point at the ADVANCED MENU in the menu using the ▼/▲
button, then press the ► button.
(3) Point at the SETUP in the left column of the menu using the ▼/▲button, then press
the ► button.
(4) Point at the LAMP & FILTER using the ▼/▲button, then press the ► button.
(5) Point at the LAMP HOURS using the ▼/▲ button, then press the ► button. A dialog appears.
(6) Press the ► button to select "OK" on the dialog. The lamp time is reset.
CAUTION
removed.
NOTE
• Reset the lamp hours only when you have replaced the lamp, for a
suitable indication about the lamp.
LW502/LWU502 User's Manual - Operating Guide
020-001057-01 Rev. 1 (06-2016)
DT01935
►Do not touch the interior of the projector, while the lamp is
)
Maintenance
Lamp cover
3
4, 5
Handles
6
103