Christie LW502 User Manual page 52

Operating
PbyP (Picture by Picture) / PIP (Picture in Picture) (continued)
 PbyP / PIP SWAP function
Press the MY BUTTON assigned the PbyP / PIP SWAP (84). The position of
the area is exchanged without any setting change.
main sub
area area
NOTE
• For some signals, it may not be displayed correctly in the PbyP / PIP
mode, even if it can be displayed properly in the normal mode.
• PbyP / PIP is unavailable when MANUAL is selected in GEOMETRY
CORRECTION > EDGE BLENDING > MODE.
 Changing the size of main area in PbyP mode
Using ▲/▼ buttons on the remote control changes the size of main area in
PbyP mode.
main area
sub area
 Changing the position of sub area in PIP mode
1. Select INPUT MENU > PbyP / PIP SETUP > PIP POSITION (67).
2. Using ▲/▼ buttons on the remote control changes the position of sub area
in PIP mode.
main area
sub area
LW502/LWU502 User's Manual - Operating Guide
020-001057-01 Rev. 1 (06-2016)
sub main
area area
PbyP mode
main area sub area
main area
sub area
main area
sub area
PIP mode
main area
main area
sub area
sub area
main area
sub area
main area
sub area
50