Changing The Frequency Of Remote Control Signal - Christie LW502 User Manual

Remote control

Changing the frequency of remote control signal

The accessory remote control has the two choices on signal frequency Mode
1:NORMAL and Mode 2:HIGH. If the remote control does not function properly,
attempt to change the signal frequency.
To set the Mode, press the combination of two buttons listed below simultaneously
for about three seconds.
(1) Set to Mode 1:NORMAL
VOLUME - and RESET buttons
(2) Set to Mode 2:HIGH
MAGNIFY OFF and ESC buttons
REMOTE FREQ. in the SERVICE item of
the OPTION menu (89) of the projector to be controlled should be set to the
same mode as the remote control.
LW502/LWU502 User's Manual - Operating Guide
020-001057-01 Rev. 1 (06-2016)
(2)
INPUT
ASPECT
MAGNIFY FOCUS
ON
MAGNIFY
OFF
OFF button
PAGE
UP GEOMETRY
DOWN INTERACTIVE
ESC
ESC
button
OSD MSG
(1)
MYBUTTON
1 2
PbyP AUTO FREEZE
ZOOM VOLUME
+ + +
VOLUME -
- - -
button
PICTURE MUTE
NETWORK BLANK
MENU
RESET
ENTER
button
RESET
28