Christie LW502 User Manual page 92

OPTION menu
Item
SERVICE
(continued)
(continued on next page)
LW502/LWU502 User's Manual - Operating Guide
020-001057-01 Rev. 1 (06-2016)
Selecting this item displays COMMUNICATION
menu.
In this menu, you can configure the serial
communication settings of the projector using the
CONTROL port.
• Select an item using the cursor buttons ▲/▼.
Then pressing the ► button opens the submenu
for the setting item you selected. Or, pressing
the ◄ button instead of the ► button makes the
menu back to the previous one without changing
the setup. Each submenu can be operated as
described above.
• When COMMUNICATION TYPE (below) is
set to OFF, the other items except STACK in
COMMUNICATION menu are invalid.
• For the function of serial communication, refer to
the Network Guide.
COMMUNICATION TYPE
COMMUNICATION Select the communication type for transmission
using the CONTROL port.
NETWORK BRIDGE: Select this type, if it is
OFF: Select this mode to receive RS-232C
• OFF is the default setting.
• When you select the NETWORK BRIDGE, check
the item, TRANSMISSION METHOD (91).
・When NETWORK BRIDGE is selected, RS-232C
menu of CONTROL TERMINAL cannot be set. The
setting of RS-232C is forcibly set to CONTROL.
Description
NETWORK BRIDGE (WIRELESS)

NETWORK BRIDGE (WIRED)

OFF
required to control an external device as a
network terminal, using this projector from the
computer. Select WIRELESS or WIRED as your
network connection mode.
The CONTROL port does not accept RS-232C
commands (7. Network Bridge Function in
the Network Guide).
commands using the CONTROL port.
90