Christie LW502 User Manual page 63

Item
OVER SCAN
V POSITION
H POSITION
(continued on next page)
LW502/LWU502 User's Manual - Operating Guide
020-001057-01 Rev. 1 (06-2016)
Using the ◄/► buttons adjusts the over-scan ratio.
Small (It magnifies picture) ó Large (It reduces picture)
• This item can be selected for a video signal.
TM
• For HDMI and HDBaseT
if either (1) or (2) applies.
(1) DIGITAL FORMAT item in the INPUT menu for selected port is
set to VIDEO.
(2) DIGITAL FORMAT item in the INPUT menu for selected port is
set to AUTO, and the projector recognizes that it receives video
signals.
Using the ◄/► buttons adjusts the vertical position.
Down ó Up
• Over-adjusting the vertical position may cause noise to appear on
the screen. If this occurs, reset the vertical position to the default
setting. Pressing the RESET button when the V POSITION is
selected resets the V POSITION to the default setting.
• When this function is performed on a video signal, the range of
this adjustment depends on OVER SCAN (above) setting. You
cannot adjust when OVER SCAN is set to 10.
• This function is unavailable for a signal from the LAN, HDMI 1,
HDMI 2 or HDBaseT port.
Using the ◄/► buttons adjusts the horizontal position.
Right ó Left
• Over-adjusting the horizontal position may cause noise to appear on
the screen. If this occurs, reset the horizontal position to the default
setting. Pressing the RESET button when the H POSITION is selected
resets the H POSITION to the default setting.
• When this function is performed on a video signal, the range of
this adjustment depends on OVER SCAN (above) setting. You
cannot adjust when OVER SCAN is set to 10.
• This function is unavailable for a signal from the LAN, HDMI 1,
HDMI 2 or HDBaseT port.
SIZE AND POSITION menu
Description
TM
signals, this item can also be selected
61