About The Remote Control Signal - Christie LW502 User Manual

About the remote control signal

The remote control works with
the projector's remote sensor.
This projector has a remote
sensor on the front.
The sensors can sense signals
within the following range:
60 degrees (30 degrees to the
left and right of the sensor)
within about 3 meters.
NOTE
• You can deactivate one of the sensors using the REMOTE RECEIV.
item in the SERVICE menu of the OPTION menu (89).
• The remote control signal refl ected in the screen may be available. If it is
diffi cult to send the signal to the sensor directly, try to make the signal refl ect.
• The remote control uses infrared light to send signals to the projector (Class
1 LED). Use the remote control in an area free from obstacles that could block
the remote control's signal to the projector.
• The remote control may not work correctly if strong light (such as direct
sun light) or light from an extremely close range (such as from an inverter
fl uorescent lamp) shines on the remote sensor of the projector. Adjust the
position of projector avoiding those lights.
LW502/LWU502 User's Manual - Operating Guide
020-001057-01 Rev. 1 (06-2016)
(approx.)
3m
30° 30°
Remote control
29